Reland Sun Angle Sensor Module SW-520D Golden Ball Switch Tilt Sensor Module

Module instructions: 1. Please refer to the wiring diagram below for detailed instructions for the wiring of this module. 2. The switch output of the module depends on the on-off and on-off of the Angle switch. When the Angle switch is off, DO outputs high level, while when the Angle switch is on-off, DO outputs low level. 3. The output end can be directly connected with the microcontroller to detect high and low level through the microcontroller, so as to detect the Angle change; 4. The output end can directly drive the relay module, which can form a high-power Angle switch to protect the function of automatic power off when the electrical equipment and other products are dumped. USES: All kinds of products tilt, tipping trigger alarm, dumping power sensor, tilt sensor. 1. High sensitive Angle switch SW-520D is adopted as the sensor. 2, Comparator output, signal clean, good waveform, strong driving capacity, more than 15mA. 3. Operating voltage: 3.3v-5v 4. Output form: digital switch output (0 and 1) 5. Fixed bolt holes are provided for easy installation 6. PCB size of small board: 3.2cm x 1.4cm 7. Use wide voltage LM393 comparator 1 * Angle Sensor Module 1.Due to the manual measurement and different measurement methods, the actual size could be slightly different. 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the website's photo and the actual item could be slightly different.

• Operating voltage: 3.3v-5v
• Output form: digital switch output (0 and 1)
• Use wide voltage LM393 comparator