R QIDI TECHNOLOGY Filament Dryer Box, Filament Storage Box for 3D Printer Filament, Keeping Filaments Dry During 3D Printing, Compatible with 1.75mm PA12-CF, PLA, PETG, ABS, UltraPA, S-White, etc
€15.20
Preis bei Onlinekauf
Kostenloser Versand
30 Tage kostenlose Rückgabe
Verkauft und versendet von copisteriaunio.egardata.net
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€15.20
Preis bei Onlinekauf
Kostenloser Versand
30 Tage kostenlose Rückgabe
Verkauft und versendet von copisteriaunio.egardata.net
30 Tage kostenlose Rückgabe Details
Produktdetails
| Artikelnummer | 225967861 | Erscheinungsdatum | 2026/05/09 | Listenpreis | €15.20 | Modellnummer | 225967861 | ||
|---|---|---|---|---|---|---|---|---|---|
| Kategorie | |||||||||
- 【Keep Filament Dry during 3D printing】Wet 3D printing filament will caused to stringing, clogging, poor adhesion, and Layer Shift. The QIDI TECH filament dryer box helps to dry excess moisture, improve your 3D model, and make the filaments say goodbye to the troubles of drawing, clogging, and poor adhesion.
- 【Comprehensive Dust-proof & Moisture-proof】This filament dry box's lid is easy to remove and install while providing a secure and airtight seal, which can block the air circulation inside and outside the consumable box as much as possible, which increase the life of filaments. It can improve the printing model stability of water-absorbent filaments, and prevent model printing from drawing wire.
- 【Space Saving】Qidi dry box can be easily installed on the existing spool holder on top of the printer unit, which can keep the filament dry while printing, and greatly save space for you.
- 【No Preheating & Power Supply】This is a great option for independent filament drying without the need for preheat printing. And you do not need any electricity and power supply to keep the drying of the 3D printer filament.
- 【Reusable Drying Pack】The inside of the dryer box is matched with a desiccant to ensure that there will be no changes in air and humidity within 30 days. And it can be reused. You can bake it in the oven at low temperature for 2-5 hours, and then you can continue to use it.
- 【High Compatibility】Support the maximum capacity: Φ210*85.5(H)mm. Compatible with 99% of the mainstream 3D filament brands and 1.75mm filament diameters; Works perfectly with PLA、PLA+、PETG、TPU、ABS etc, Including high-end filament PA、PC.
Korrektur der Produktinformationen
Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.
Korrekturanfrage