JSM1E-12V-5-H15 JSM1-12V-5 255-1240 12V 15A SPDT 5-Pin PCB Automotive Power Relay, 5 Pack, Through Hole Sealed 1 Form C PC Pin for Window Door Lock Horn Circuit Board

Product Fact Block: JSM1E-12V-5-H15 relay model reference for compatible 12VDC, 15A, SPDT / 1 Form C, 5-pin PC pin through-hole circuit board applications. Also check against JSM1-12V-5, JSM1E-12V-5 and 255-1240 markings before ordering.Compatibility Checklist: Match the original relay marking, coil voltage, contact form, contact rating, pin count, solder footprint, board hole pattern, relay height and schematic. This is a soldered PCB relay, not a plug-in automotive blade relay.Typical Circuit Use: Depending on the control board design, this JS-M style relay may be used in power window, door lock, horn, interior lighting, intermittent wiper, antenna, power seat, power sunroof, stereo or lift gate relay circuits.Install Notes: Disconnect power before service. Desolder and remove the failed relay carefully, inspect board pads and traces, then solder the replacement only after confirming the pin layout and circuit rating match.Important Notes: Vehicle, circuit and model names are for compatibility verification only. Confirm the original relay number, circuit board pattern and service manual before ordering.

• [MODEL & SPEC CHECK] JSM1E-12V-5-H15 replacement relay model reference, also check against JSM1-12V-5, 255-1240 and JSM1E-12V-5 markings. 12VDC coil, 15A contact rating, SPDT / 1 Form C contact form, 5-pin PC pin layout, through-hole mount, sealed construction, non-latching coil, 225 ohm coil resistance and 640 mW coil power.
• [PCB RELAY APPLICATIONS] Designed for compatible circuit boards and automotive-style relay modules using the same JS-M 12V 15A SPDT footprint. Typical relay-controlled circuits may include power window, door lock, horn, interior lighting, intermittent wiper, car antenna, power seat, power sunroof, car stereo or lift gate systems, depending on the original board design.
• [PIN & FOOTPRINT CHECK] Before ordering, compare the original relay body marking, 5-pin solder layout, 1 Form C schematic, coil voltage, contact rating, board hole spacing and available height. This relay is not a plug-in blade relay; it is a PC pin through-hole relay for soldered circuit board repair or replacement.
• [REPAIR VERIFICATION] May help restore circuit operation when diagnosis confirms the original PCB relay is damaged, overheated, corroded, missing or has worn contacts. Always confirm the failed relay with a meter, service information and board schematic before replacement; this part does not diagnose or guarantee repair of the complete control module.
• [INSTALLATION NOTE] Disconnect power before service, desolder the old relay carefully, avoid lifting circuit board pads, clean flux residue and inspect nearby traces, connector pins and solder joints. Brand names and model numbers are used only as relay model references; verify by original part number, pin layout and circuit board pattern.