Disc Cutter 14 Round Punches - for Jewelry Making - SFC Tools - 25-154

Convenient smaller size circle 14 punches sized 3, 4.5, 5, 6, 7, 7.5, 8, 8.5, 10, 11, 12, 13, 14, and 16 millimeters Punches are machined flat and smooth on the cutting end This smaller size circle disc cutter set features 14 punches that range in size from 3mm, 16mm and a square steel disc cutting block. You can cut soft sheet metal (gold, silver, copper, brass, etc.) up to 20 ga. This small disc cutter measures approximately 4-1/4"x1-7/8". The punches are machined flat and smooth at the cutting end to create perfect circle-shaped blanks every time, and beveled at the other end for use with a heavy mallet or hammer. To use the disc cutter, remove all punches from the block, and select the size punch you would like. Place your sheet metal in the slot and place your punch, sharp side against the metal, in the correct slot. Strike the beveled side of the punch with a heavy mallet until it pierces through the sheet metal. Be careful of your fingers and other items on your work surface. We recommend using a brass mallet (1lb. to 2lb. preferred) or dead blow to prevent damage to your disc cutter. You should also use Pro-Cut lube to reduce friction and wear on your punches. IMPORTANT: Always position a shim of the same thickness of the metal being cut directly across from the metal in the disc cutter block. This keeps the plates balanced and helps ensure a nice clean cut.

• Cut circles out of sheet metal.
• Convenient smaller size circle
• Punches are machined flat and smooth on the cutting end
• Will cut up to 20 gauge metal
• 14 punches sized 3, 4.5, 5, 6, 7, 7.5, 8, 8.5, 10, 11, 12, 13, 14, and 16 millimeters