Dental Wet Model Shaping Trimmer Abrasive diamond Disc Wheel Lab Equipment New supply by Super DentalQ

★Features★ 1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve. 2. Connect the waste-disposal tube to the unit. 3. Connect the power cord, and switch on the power switch (O=off, l=on) 4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18). 5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet). ★Specifications★ Voltage: 110V/60Hz±10%,220V/50Hz±10% Power: 500W Rotational Speed: 2800 rpm Dimensions: 44×35×35cm Weight of the trimmer: 20kg ★Attention★ If there is some abnormal noise when working on Possible reason：① Axon is loosing ② Disc is not plain enough。 How to solve it： ①Dissemble the disc⒃ with spanner，make the snap Ring tightly；② change the disc。 The machine does not work when power on Possible reason： ① fuse get burnt；② motor get burnt；③ switch get wrong. How to solve it： ① change the fuse（22） which inside the socket；② change the motor；③ change the switch。 ★Packing list★ Wet Model Trimmer Abrasive Disc Wheel Lab Equipment *1 Power cord *1

• This is a necessary tool to trim plaster model, this machine is made of anti-rust all cast aluminum.
• The angle can be adjusted between 0-20 °. Users can achieve perfect trimming quality.