Adjustable Holder Mount Fit for 50-80mm CO2 Tube Used for Engraving Machine ABS & Rubber & Metal Engraving Machine

Adjustable Holder Mount Fit For 50-80mm CO2 Tube Used for Engraving Machine ABS & Rubber & MetalAdjustable Holder Mount Fit For 55-80mm CO2 Laser-Tube Engraving MachineSpecifications:Condition: newColor:Grey & Black ABS & Rubber & MetalSize: approx.11.5x6.5cm(4.61x2.64inch)(LxW)Height: approx.10-16.5cm(3.94-6.50inch)Item included: 1 x CO2 Laser-Tube HolderCompatible With: fit for Dia. 55-80mm Laser-Tube use: Put four screws on the four oblong holes at the bottom of the tube bracket to fix it on a flat surface. Put the laser-tube and adjust the tube bracket to make the height of the laser-tube appropriate and form an angle of about 45 degrees with the reflector next to the light emitting end of the laser-tube. After tighten all screws of the tube bracket.Features:The diameter of the tube is adjustable, suitable for laser-tubes with a diameter of 55-80cm, to avoid the tube holder not being Use special the is not aging, the laser-tube can be fixed firmly, and the optical for is not easy to deviate;Lifting screw, easy height simple installation;Note:1) All dimensions are measured by hand, there may be small deviations.2) Color may vary slightly due to the color setting of each individual monitor.Package included:1 * Adjustable Holder Mount

• Lifting screw, simple installation
• 1) All dimensions are by hand, there may be small
• Use special the is not aging, the laser-tube can be fixed firmly, and the optical is not easy to
• The diameter of is adjustable, suitable for laser-tubes diameter of 55-80cm, to avoid holder not being
• Note