210k BTU Titanium Tube and Shell Heat Exchanger for Saltwater Pools/Spas os

210,000 BTU Titanium Tube and Shell * Opposite Side Ports* GPM Boiler Side – 9.13* GPM Pool Side – 63.94* Boiler Ports – 11/2" NPT* Pool Ports - 1 1/2" NPT*Port to Port - 13 1/4"* Diameter – 3 3/16"* Length – 20"* Number of Tubes - 30* PSI Drop Hot – .38* PSI Drop Cold – 1.06* Working Pressure - 80 PSI* BTU rated with 180F Boiler and 80F PoolThis unit is suitable for pools/spas that are 18,060 gallons.These heat exchangers are constructed with a Titanium shell and Titanium corrugated inner tubes to ensure high velocities inside the unit.This is a very reliable, efficient and cost effective way to transfer heat indirectly between any boiler circuit and any pool or spa circuit. The units are designed for both horizontal and vertical mounting. Port sizes: (to/from Boiler) 1 1/2" - (to/from Pool) 1 1/2".It is recommended to always install the unit with the mounting bracket (mounting brackets included with each unit) fixed to a wall, and/or ceiling or floor to prevent water hammer or vibrations which could damage the unit.IMPORTANT!! Always install the Titanium Pool & Spa Heat Exchanger in a counter flow pattern. The units should be installed downstream of the filtration and pumping equipment. The boiler water must be assisted and the usual precautions taken to prevent air locks.The pool water pump should be controlled by a thermostat in the pool pipe work before the heat exchanger and set at the required temperature.Titanium Pool and Spa Heat Exchangers are suited for a large range of chemical environments and conditions, due to a thin, invisible, but extremely protective surface oxide film (primarily TiO2). Titanium is especially known for its elevated resistance to localized attack and stress corrosion in aqueous chlorides (e.g., brines, seawater) and othe